Home
HomeProductsAbout UsContact Us
Products
End Users
Sales Reps
Sizing and Specs
UL Certifications
 
Perfit Logo
Hazardous Location Connectors
Metal Clad (Type MC Series) Cable Connector
WTPC Installation Page
UL mark
WTUPC Installation Page
(WTPC) WATER TIGHT POURING CHAMBER
 
(WTUPC) WATER TIGHT UNION POURING CHAMBER

CLASS I (DIVISION I & II); CLASS II (DIVISION I & II); CLASS III

The (WTPC) connector is a watertight, flame retardant connector that provides for bonding and termination of the metal clad cable to a knockout box. This connector is easily installed by screwing the body onto the metal sheath, and securing the connector to the box using the gasket, locknut, and bushing provided. The 3M 2130 sealant is then injected to complete the termination.
 
The (WTUPC) connector is a watertight, flame retardant connector that provides for bonding and termination of the metal clad cable going to electrical equipment or a haz-loc box with a threaded entrance. This connector is easily installed by loosening the gland nut, screwing the body onto the metal sheath, tightening the male hub into the threaded entrance of the equipment or box, and tightening the hub and gland nuts. The 3M 2130 sealant is then injected to complete the installation.
 
 

Both of these connectors are designed for hazardous installations and can withstand chemicals, water spray, and other hazardous conditions.

For extra corrosive areas, pre-cut lengths of heat shrink are available up to 3½" trade sizes.

These products are listed by Underwriters Laboratories for Class I (Division I and II) Group A, B, C, D; Class II Group E, F, G; and Class III hazardous areas for both the United States and Canada. This listing is valid for all connector sizes ½" thru 4".

Hazardous demo
THE SEAL
♦ 3M Brand 2130 Flame Retardant, Two-Part, Polyurethane Resin
♦ Withstands Extreme Temperature Conditions
♦ Can Be Sealed at 0°C
♦ The Most Complete and Void Free Seal on the Market
 
THE SYSTEM
♦ Duo Pack Cartridge to Assure Correct Proportions
♦ Static Mixing Nozzle for Easy, Thorough Mixing and Application
♦ Duplex Gun (DAG-2) for Fast, Clean Injection of Sealant (sold separately)
 
Home * Products * Sizing & Specs * Installation Instructions * Sales Reps * End Users * About Us * UL Certification * Contact Us

Catalog PDF